Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In with Google

In this Discussion

How to smooth out the Progasm ICE?
  • aliquisaliquis
    Posts: 77
    How would you recommend smoothing out the seam on a Progasm ICE?

    It's not there by much but it can be felt, I would prefer to not ruin the surface. And no power tools =P
  • B MayfieldB Mayfield
    Posts: 2,087
    I would concur that this seam (the molding line) is very small, but if you feel the need to deal with it, you will have to do some progressive sanding. Start with a wet/dry sandpaper 320-400 grit to work the seam down and then switch to 1000 and 2000 grit sandpapers for smoothing. The latter two products are normally available for clear coat sanding for automotive finishes. This sanding can be done dry or with water. Why water? It keeps the paper from getting clogged up with particles of plastic. Be advised that you may not get the finish of the ICE back to the way that it looked prior to the sanding, i.e. it may look a little dull in the areas that you've sanded.

    Good luck

    BF Mayfield
  • rookrook
    Posts: 1,742
    No experience with the ICE but a bit of toothpaste on a soft cloth works on some clear plastics. Goggle for a 'jeweler's rouge cloth' -- also a winner for final finishing.